Finally getting to wrapping up my Z-Axis, and in looking at the Rod Ends, I had a question.
My Rod Ends have a squared flat surface, but more tapered. So I was wondering should I put a washer on the rod end, then screw it into the Z-Bed-Arm RodEnd-Support and then put a nut on it.
Or are you wanting the Rod End to essentially dig into the Z-Bed-Arm RodEnd-Support to help keep it vertical.
Back to making sure my Z Rails are square, and finishing up the HD-9 XY.
1 post • Page 1 of 1