I'm planning two builds, one 180xy 190z for high temperature (90c+ chamber) and a 331xy 440z for speed.
The BOM just says 60mm motors for the Z, looking in the forums I'm not seeing any references to specific models other than one mention of the E3D super whoppers.
Would thes steppers below work just as well? Would the super whoppers or even the high torque be a better?
LDO NEMA 17 MOTOR SUPERMAC LDO-42STH60-2004AC
1.8° Step Angle.
200 Steps Per Revolution.
9Kg-cm (125oz) Holding Torque.
25mm Output Shaft (5mm diameter)
1 post • Page 1 of 1