Struggling to print good Y carriages

jbasol
What is a BOM?
Posts: 16
Joined: Thu Sep 03, 2020 3:52 pm
Has thanked: 1 time

Re: Struggling to print good Y carriages

Post by jbasol »

I'm using the Ultimaker Cura slicer (V4.8). I don't recall seeing the break support into chunks setting. I will have to look for that! Thanks! I did eventually flip the carriage up on end and printed it in an easier orientation to deal with the support. They seem strong enough. Hopefully they at least work for getting my HevORT running to reprint them out of something stronger than PETG. :)

jbasol
What is a BOM?
Posts: 16
Joined: Thu Sep 03, 2020 3:52 pm
Has thanked: 1 time

Re: Struggling to print good Y carriages

Post by jbasol »

Found 'break support into chunks" under 'experimental'. That DOES help. Thanks!

Post Reply