Free set of 3D printed parts to anyone in the US

Post Reply
guitartoys
Printed Parts ready
Posts: 59
Joined: Mon Dec 28, 2020 11:29 am
Has thanked: 2 times
Been thanked: 10 times

Free set of 3D printed parts to anyone in the US

Post by guitartoys »

OK,

I printed the XY motor brackets in black and liked red better. So I have one of each of those

Then I printed out the parts with an attached brim as I was worried about warpage, but turned out I didn't need them, so I printed another set. But with these, you will need to trim off the brim. (I started to trim some)

I printed them in PETG, and they turned out well. See Photo

I basically have the High Temp XY and the Version 2 Z Axis.

If there's anyone in the US who wants them, I'll chuck them in a box and ship them to you.

Michael
You do not have the required permissions to view the files attached to this post.

Ely
What is a BOM?
Posts: 2
Joined: Mon Jan 25, 2021 7:10 pm
Has thanked: 3 times

Re: Free set of 3D printed parts to anyone in the US

Post by Ely »

I would love to have them if they are still available.
I've spent the last two days looking at documentation and planning on building one.

guitartoys
Printed Parts ready
Posts: 59
Joined: Mon Dec 28, 2020 11:29 am
Has thanked: 2 times
Been thanked: 10 times

Re: Free set of 3D printed parts to anyone in the US

Post by guitartoys »

Send me a private message with your address, or provide me with your email address.

M

User avatar
MirageC
Site Admin
Posts: 497
Joined: Fri Jul 24, 2020 12:52 pm
Has thanked: 7 times
Been thanked: 54 times

Re: Free set of 3D printed parts to anyone in the US

Post by MirageC »

Good to see the community work together like this :)

guitartoys
Printed Parts ready
Posts: 59
Joined: Mon Dec 28, 2020 11:29 am
Has thanked: 2 times
Been thanked: 10 times

Re: Free set of 3D printed parts to anyone in the US

Post by guitartoys »

Well, I've been a poor representative, as they are literally still sitting on my desk, as I had to move.

I just finished boxing them up, and will send them out next week.

M

Post Reply