Printing on a cold bed with EVA glue?

Raise the community awareness on other 3D printers type and development
Post Reply
User avatar
Jet
What is a BOM?
Posts: 13
Joined: Sat Jul 25, 2020 8:23 pm
Has thanked: 3 times

Printing on a cold bed with EVA glue?

Post by Jet »

The note describes the strange possibility of printing on a cold table.

Author pre-heated the glass to 115 ° C. Then, author took a glue gun stick and smeared it with a spatula on the glass, a thin layer. After that, a successful printing occurred on this cold table. Then the author heated the glass to remove model from the glass.
eva-glue-nylon.jpg

Source [rus]:
https://3dtoday.ru/blogs/bulagen/novyi- ... plastikami
You do not have the required permissions to view the files attached to this post.
🇺🇦

User avatar
WallK
What is a BOM?
Posts: 7
Joined: Fri May 14, 2021 3:07 am
Has thanked: 3 times

Re: Printing on a cold bed with EVA glue?

Post by WallK »

He even printed with nylon grass trimmer string!
What a collection of successful experiments! (:

Post Reply