Can you share your method of calibration with me

[derobiwan]

So I have almost finished my HevORT build, just missing the parts cooling solution and I am done.
I have tried to print the calibration cube already with very poor results and I need to go into calibration now.
I PID tuned my hotend and bed. I managed to setup my auto bed leveling with quite some learning regarding decemal points in different languages. (, vs .)
I would go for Extruder calibration now and then need to calibrate the Axis.
After that I would try to get pressure advance working.

It is my first Duet Board and I still need to learn a lot.
Would there be any piece of advise that you could share with a still learning person?
What are you doing to get your printer to optimal printing results?

Thank you for any advice shared!

[PonderStibbons]

This is one of the "standard" methods: https://reprap.org/wiki/Triffid_Hunter' ... n_Guide/de

I currently do not have experience with a DUET board, but the basic method should be the same!

Kind regards,
Martin