Can you share your method of calibration with me

Post Reply
derobiwan
What is a BOM?
Posts: 4
Joined: Tue Oct 13, 2020 2:42 am
Been thanked: 1 time

Can you share your method of calibration with me

Post by derobiwan »

So I have almost finished my HevORT build, just missing the parts cooling solution and I am done.
I have tried to print the calibration cube already with very poor results and I need to go into calibration now.
I PID tuned my hotend and bed. I managed to setup my auto bed leveling with quite some learning regarding decemal points in different languages. (, vs .)
I would go for Extruder calibration now and then need to calibrate the Axis.
After that I would try to get pressure advance working.

It is my first Duet Board and I still need to learn a lot.
Would there be any piece of advise that you could share with a still learning person?
What are you doing to get your printer to optimal printing results?

Thank you for any advice shared!

PonderStibbons
What is a BOM?
Posts: 16
Joined: Tue Nov 03, 2020 9:14 am
Been thanked: 2 times

Re: Can you share your method of calibration with me

Post by PonderStibbons »

This is one of the "standard" methods: https://reprap.org/wiki/Triffid_Hunter' ... n_Guide/de

I currently do not have experience with a DUET board, but the basic method should be the same!

Kind regards,
Martin

Post Reply