Page 1 of 1

Frame BOM

Posted: Fri Dec 17, 2021 12:30 am
by DLrocket89
Looking at the frame BOM - there are 104 nuts, 104 screws, and 26 corners. Are the nuts and screws for the corners?

What about other nuts to put on stuff down the road? Should I use the nuts that can be slipped in after it's together?

There are also things about the blind joints - does this require drilling holes through the extrusion? And a bunch of the ends would need to be tapped, right? I'm thinking of ordered from, and for $0.50 they'll tap ends and I'm thinking I'll do that to save myself the misery.