Just a question about the Z extrusions

Post Reply
mtsgsd
What is a BOM?
Posts: 4
Joined: Tue Jun 01, 2021 2:20 pm

Just a question about the Z extrusions

Post by mtsgsd »

This is not meant as a criticism, as I'm not an engineer by any means, but I'm curious why the design adds an extra extrusion on the front two uprights for the Z axis. Why not use the frame? Or add a single extrusion to the middle rail in back?
Like I said, I'm just curious about the reasoning behind it. :D

Mr Yod
What is a BOM?
Posts: 17
Joined: Thu May 06, 2021 5:32 pm
Has thanked: 2 times
Been thanked: 3 times

Re: Just a question about the Z extrusions

Post by Mr Yod »

I think: more rigidity.
With a second extrusion on the back you wouldn't have it.

Post Reply