Hello to all the builders of this great printer.
So I'm finally ready to show my working versions of Hevort and MiniHevort
Hevort frame reduced to 560x560x900 due to moving
xy axis ST MGN12
osa z I liked the principle of the RatRig v3core printer basically similar, but a cheaper solution so far satisfaction 3x MGN 12
Hextrudort with water cooling own design modified from E3D V6 air cooling heating element 70w motor NEMA17 LDO
Bed alu board 6mm heat-resistant burnout, heating silicone self-adhesive mat 1400w 230v 350x350 with thermal fuse 10A 120°C for the printing surface I use sklotextit G10 1.5mm works flawlessly I recommend
Cover Butterfly 3mm plexiglass
Power supply 24v 400w, switching bed SSR 40A, Raspberry pi zeroW2, FW Klipper BlTouch, motors 3x NEMA 17HS19 204s1 6x, BTT TMC2209 v1,2 6x, BTT Octopus v1.1, lighting with regulation
Show us your beautiful builds !
2 posts • Page 1 of 1