Necessary size of printer to print parts needed for HevORT

Post Reply
japORT
What is a BOM?
Posts: 2
Joined: Thu Mar 18, 2021 5:36 pm

Necessary size of printer to print parts needed for HevORT

Post by japORT »

Hi there! I've been following this project for some time now and am finally ready to build the printer.

I'm thinking that around a 250mm cube build volume would be a good start.

I currently have a small printer 120mm cubed print area.

Will this be enough to print the necessary parts?

Thanks!

User avatar
firegun
Frame Assembler
Posts: 29
Joined: Wed Jan 13, 2021 2:49 pm
Has thanked: 4 times
Been thanked: 1 time

Re: Necessary size of printer to print parts needed for HevORT

Post by firegun »

Hey, I'm on printing process now... didn't finished yet, but took a quick measurement on all parts I have and I believe you will be fine. If you want to double check, bigger pieces are the motor mounts (for Z and gantry too) and print head carriage, rest is small enough for sure.

japORT
What is a BOM?
Posts: 2
Joined: Thu Mar 18, 2021 5:36 pm

Re: Necessary size of printer to print parts needed for HevORT

Post by japORT »

Okay great! I do have access to a 400x400 printer if needed

Post Reply